MetalworkingFun Forum › Machining › Projects v
Video camera mount

Thread Modes
Video camera mount
chucketn Offline
Junior
****
Posts: 375
Threads: 53
Joined: Jun 2013
Location: Jonesborough, TN
#6
09-16-2013, 02:47 PM
Can't wait to see a video from the new setup!

Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
Reply
Thanks given by:


Messages In This Thread
Video camera mount - by doubleboost - 09-15-2013, 01:56 PM
RE: Video camera mount - by tekfab - 09-15-2013, 02:02 PM
RE: Video camera mount - by EdK - 09-15-2013, 02:46 PM
RE: Video camera mount - by doubleboost - 09-15-2013, 02:56 PM
RE: Video camera mount - by doubleboost - 09-16-2013, 02:40 PM
RE: Video camera mount - by chucketn - 09-16-2013, 02:47 PM
RE: Video camera mount - by DaveH - 09-17-2013, 02:18 AM
RE: Video camera mount - by doubleboost - 09-17-2013, 03:27 PM
RE: Video camera mount - by chucketn - 09-17-2013, 03:51 PM
RE: Video camera mount - by Micktoon - 09-17-2013, 04:15 PM
RE: Video camera mount - by EdK - 09-17-2013, 04:26 PM
RE: Video camera mount - by LJP - 09-17-2013, 08:09 PM
RE: Video camera mount - by krv3000 - 09-20-2013, 04:41 PM



Users browsing this thread: 1 Guest(s)