09-18-2013, 05:58 AM
I think I'll go with a 36" x 30" x 1/2" plate. The cost difference between 3/8 and 1/2" is only $28.
Thanks for all of the advise.
Ed
Thanks for all of the advise.
Ed
|
Help Welding Table Thickness
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Welding Table Thickness - by EdK - 09-17-2013, 07:08 PM
RE: Welding Table Thickness - by Mayhem - 09-17-2013, 07:43 PM
RE: Welding Table Thickness - by f350ca - 09-17-2013, 08:19 PM
RE: Welding Table Thickness - by EdK - 09-17-2013, 08:24 PM
RE: Welding Table Thickness - by Mayhem - 09-17-2013, 08:40 PM
RE: Welding Table Thickness - by EdK - 09-18-2013, 05:36 AM
RE: Welding Table Thickness - by mattinker - 09-18-2013, 05:52 AM
RE: Welding Table Thickness - by TomG - 09-17-2013, 08:51 PM
RE: Welding Table Thickness - by dallen - 09-17-2013, 09:15 PM
RE: Welding Table Thickness - by arvidj - 09-17-2013, 09:16 PM
RE: Welding Table Thickness - by EdK - 09-18-2013, 05:58 AM
RE: Welding Table Thickness - by stevec - 09-18-2013, 06:58 AM
RE: Welding Table Thickness - by Mayhem - 09-18-2013, 10:51 AM
RE: Welding Table Thickness - by stevec - 09-18-2013, 11:30 AM
RE: Welding Table Thickness - by EdK - 09-18-2013, 11:47 AM
RE: Welding Table Thickness - by oldgoaly - 09-18-2013, 12:33 PM
RE: Welding Table Thickness - by Mayhem - 09-18-2013, 03:09 PM
RE: Welding Table Thickness - by doubleboost - 09-18-2013, 04:03 PM
RE: Welding Table Thickness - by stevec - 09-18-2013, 06:22 PM
RE: Welding Table Thickness - by Mayhem - 09-19-2013, 01:23 AM
|
Users browsing this thread: 1 Guest(s)