|
How to Power Tap
|
09-18-2013, 01:31 PM
When I was running a radial drill years ago (1982-1987) I tapped a LOT of blind holes under power. I got very good at it because I'd wrap some masking tape around the tap at the depth I needed to go and never broke a tap! I used spiral point taps and simply dug the chips out after it was done. They were mostly 1/2-13, 5/8-11 and 3/4-10 threads, so very sturdy taps.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
How to Power Tap - by TomG - 09-17-2013, 08:37 PM
RE: How to Power Tap - by f350ca - 09-17-2013, 08:55 PM
RE: How to Power Tap - by PixMan - 09-17-2013, 10:48 PM
RE: How to Power Tap - by TomG - 09-17-2013, 10:55 PM
RE: How to Power Tap - by PixMan - 09-17-2013, 10:59 PM
RE: How to Power Tap - by stevec - 09-18-2013, 07:37 AM
RE: How to Power Tap - by TomG - 09-18-2013, 07:53 AM
RE: How to Power Tap - by oldgoaly - 09-18-2013, 10:46 AM
RE: How to Power Tap - by stevec - 09-18-2013, 12:42 PM
RE: How to Power Tap - by PixMan - 09-18-2013, 01:31 PM
|
