Powered drawbar?
#6
I've been looking at just about everything on the internet, sure a lot of crap / phoney sites!
Just to verify you don't need to hold the brake? would I be crazy to re-purpose a older battery impact? one they are cheap, a simple DC power supply, couple of momentary switches down low where they are easy to reach, a little wire? what money a power supply will cost make up in savings on air fittings and valves. some raise / lower the impact wrench, how about a brake cable and shop made foot pedal?
oldgoaly, proud to be a member of MetalworkingFun Forum since Jun 2013.
Reply
Thanks given by:


Messages In This Thread
Powered drawbar? - by oldgoaly - 10-05-2013, 10:22 PM
RE: Powered drawbar? - by Highpower - 10-06-2013, 09:50 AM
RE: Powered drawbar? - by ScrapMetal - 10-06-2013, 07:10 PM
RE: Powered drawbar? - by oldgoaly - 10-06-2013, 08:18 PM
RE: Powered drawbar? - by Highpower - 10-06-2013, 11:09 PM
RE: Powered drawbar? - by oldgoaly - 10-07-2013, 02:45 PM
RE: Powered drawbar? - by Highpower - 10-07-2013, 04:58 PM
RE: Powered drawbar? - by oldgoaly - 10-07-2013, 05:46 PM
RE: Powered drawbar? - by oldgoaly - 10-10-2013, 09:37 PM
RE: Powered drawbar? - by Highpower - 10-10-2013, 11:14 PM
RE: Powered drawbar? - by oldgoaly - 10-11-2013, 12:19 AM



Users browsing this thread: 1 Guest(s)