The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error




Help Any Heidenhain Experts on the Forum?
#1
I've a TNC355 - (It on a Beaver Partsmaster)

Everything works fine but I have one minor irritation. I have 'program 0' set as the Tool Table which is a standard option set by parameter - tool length offsets work out just fine, but there doesn't seem to be a display mode that will tell me where the tip of the tool is in 'Z' height while the program is running. You see a line of code about to be run saying go to Z= -3.0 for instance, but the 'Actual' display shows this plus tool length compensation so a meaningless figure as you watch a part being cut. Several times I've glanced at the position display and had a heart stopping moment thinking 'heck why's it there' then realised it's this display irritation. Of course it shows correctly for the 'standard tool' but as that a Heidenhain probe I don't do a lot of machining using that !

Am I missing something basic and fundamental here ?
Andrew Mawson, proud to be a member of MetalworkingFun Forum since Oct 2013.
Reply
Thanks given by:


Messages In This Thread
Any Heidenhain Experts on the Forum? - by awemawson - 10-13-2013, 03:24 PM



Users browsing this thread: 1 Guest(s)