MetalworkingFun Forum › Machining › Projects v
Big Lathe Faceplate Project

Thread Modes
Big Lathe Faceplate Project
aametalmaster Offline
MTLMSTR
****
Posts: 410
Threads: 77
Joined: Mar 2012
Location: Salem, Ohio
#2
03-26-2012, 05:33 PM
Check out the way i turned the OD with the boring bar...Bob
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Reply
Thanks given by:


Messages In This Thread
Big Lathe Faceplate Project - by aametalmaster - 03-26-2012, 05:31 PM
RE: Big Lathe Faceplate Project - by aametalmaster - 03-26-2012, 05:33 PM
RE: Big Lathe Faceplate Project - by EdK - 03-26-2012, 05:54 PM
RE: Big Lathe Faceplate Project - by dallen - 07-20-2012, 03:39 PM
RE: Big Lathe Faceplate Project - by TomG - 07-21-2012, 08:52 PM
RE: Big Lathe Faceplate Project - by DaveH - 03-26-2012, 08:28 PM
RE: Big Lathe Faceplate Project - by Mayhem - 03-26-2012, 11:42 PM
RE: Big Lathe Faceplate Project - by doubleboost - 07-20-2012, 02:53 PM
RE: Big Lathe Faceplate Project - by krv3000 - 07-21-2012, 02:54 PM
RE: Big Lathe Faceplate Project - by Bill Gruby - 07-21-2012, 03:07 PM
RE: Big Lathe Faceplate Project - by EdK - 07-21-2012, 03:30 PM



Users browsing this thread: 1 Guest(s)