MetalworkingFun Forum › Machining › Projects v
Big Lathe Faceplate Project

Thread Modes
Big Lathe Faceplate Project
dallen Offline
Senior
*****
Posts: 1,827
Threads: 51
Joined: Apr 2012
Location: Oklahoma
#8
07-20-2012, 03:39 PM
(03-26-2012, 05:51 PM)aametalmaster Wrote: Heres another pic i found. Cutting the backside from the frontside. I don't do too much textbook machining i have to wing a lot of it...Bob

I saw this technique in Honolulu Hawaii once but the bar they were using to reach back towards the headstock with was about 3 inches square.

great looking face plate wish I could find a guy that would make those kind of casting in his spare time at work for freeThumbsupThumbsupThumbsup
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:


Messages In This Thread
Big Lathe Faceplate Project - by aametalmaster - 03-26-2012, 05:31 PM
RE: Big Lathe Faceplate Project - by EdK - 03-26-2012, 05:54 PM
RE: Big Lathe Faceplate Project - by dallen - 07-20-2012, 03:39 PM
RE: Big Lathe Faceplate Project - by TomG - 07-21-2012, 08:52 PM
RE: Big Lathe Faceplate Project - by DaveH - 03-26-2012, 08:28 PM
RE: Big Lathe Faceplate Project - by Mayhem - 03-26-2012, 11:42 PM
RE: Big Lathe Faceplate Project - by doubleboost - 07-20-2012, 02:53 PM
RE: Big Lathe Faceplate Project - by krv3000 - 07-21-2012, 02:54 PM
RE: Big Lathe Faceplate Project - by Bill Gruby - 07-21-2012, 03:07 PM
RE: Big Lathe Faceplate Project - by EdK - 07-21-2012, 03:30 PM



Users browsing this thread: 1 Guest(s)