Power lead screw for 7x12.
#9
A variable speed motor would definitely be the way to go, I think Brian has got it right for sure. I was testing it out when I put this together. The only reason the motor is painted is because I switched it off the lathe for a 3/4hp that ran much smoother. It has worked so well I haven't bothered to change anything.

Shawn
Shawn, proud to be a member of MetalworkingFun Forum since Nov 2013.
Reply
Thanks given by:


Messages In This Thread
Power lead screw for 7x12. - by Brian - 12-07-2013, 03:12 PM
RE: Power lead screw for 7x12. - by chucketn - 12-07-2013, 03:37 PM
RE: Power lead screw for 7x12. - by Brian - 12-07-2013, 04:58 PM
RE: Power lead screw for 7x12. - by Brian - 12-08-2013, 08:35 AM
RE: Power lead screw for 7x12. - by Brian - 12-10-2013, 11:26 AM
RE: Power lead screw for 7x12. - by chucketn - 12-10-2013, 11:31 AM
RE: Power lead screw for 7x12. - by Shawn - 12-10-2013, 04:35 PM
RE: Power lead screw for 7x12. - by stevec - 12-10-2013, 05:23 PM
RE: Power lead screw for 7x12. - by Shawn - 12-11-2013, 09:33 PM
RE: Power lead screw for 7x12. - by Brian - 12-12-2013, 04:12 PM



Users browsing this thread: 3 Guest(s)