Power lead screw for 7x12.
#10
That looks a mighty powerful system Shawn. I cant stop this wiper motor by hanging on to the saddle hand wheel. so yours must be great.
I wonder if it is possible to broach keyways or splines by indexing the chuck ???.
After getting the meter from the boat, I tested the draw it's 5A similar to
the motor's used on the mill table. so I will order a PWM control unit ans tap into the mill power supply.
I cant use the other end of the lead screw because I have a wheel to fine feed the saddle if I require it. one div = .001".
   

Brian.
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com Welcome
Reply
Thanks given by:


Messages In This Thread
Power lead screw for 7x12. - by Brian - 12-07-2013, 03:12 PM
RE: Power lead screw for 7x12. - by chucketn - 12-07-2013, 03:37 PM
RE: Power lead screw for 7x12. - by Brian - 12-07-2013, 04:58 PM
RE: Power lead screw for 7x12. - by Brian - 12-08-2013, 08:35 AM
RE: Power lead screw for 7x12. - by Brian - 12-10-2013, 11:26 AM
RE: Power lead screw for 7x12. - by chucketn - 12-10-2013, 11:31 AM
RE: Power lead screw for 7x12. - by Shawn - 12-10-2013, 04:35 PM
RE: Power lead screw for 7x12. - by stevec - 12-10-2013, 05:23 PM
RE: Power lead screw for 7x12. - by Shawn - 12-11-2013, 09:33 PM
RE: Power lead screw for 7x12. - by Brian - 12-12-2013, 04:12 PM



Users browsing this thread: 1 Guest(s)