MetalworkingFun Forum › Machinery › Lathes v
Spindle Crank

Thread Modes
Spindle Crank
Hawkeye Offline
Junior
****
Posts: 532
Threads: 39
Joined: Jan 2013
Location: Kelowna, BC, Canada
#3
12-16-2013, 12:55 AM
With a 14" bar, it would pull the lathe across the floor. Rotfl

The chuck body is only 3" from the back plate.
Mike

If you can't get one, make one.

Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by:


Messages In This Thread
Spindle Crank - by Hawkeye - 12-15-2013, 12:08 AM
RE: Spindle Crank - by Mayhem - 12-15-2013, 06:35 AM
RE: Spindle Crank - by Hawkeye - 12-16-2013, 12:55 AM
RE: Spindle Crank - by Mayhem - 12-16-2013, 06:27 AM
RE: Spindle Crank - by Hawkeye - 12-17-2013, 12:07 AM



Users browsing this thread: 1 Guest(s)