MetalworkingFun Forum › Machinery › Lathes › Lathe Tooling v
Carriage Stop

Thread Modes
Carriage Stop
Hawkeye Offline
Junior
****
Posts: 532
Threads: 39
Joined: Jan 2013
Location: Kelowna, BC, Canada
#11
12-16-2013, 11:52 PM
I looked around for a piece of rod to use for the stop and spotted a broken tap. Chucked it in a drill to spin against the grinder to clean up the broken end and take the tops off the teeth. I ground the pointy end to give it a small flat - less sensitive to swarf than the 1/4" diameter rod on my other lathe.
Mike

If you can't get one, make one.

Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by: stevec


Messages In This Thread
Carriage Stop - by Hawkeye - 12-15-2013, 12:25 AM
RE: Carriage Stop - by Mayhem - 12-15-2013, 06:31 AM
RE: Carriage Stop - by EdK - 12-15-2013, 09:47 AM
RE: Carriage Stop - by stevec - 12-15-2013, 06:51 AM
RE: Carriage Stop - by TomG - 12-15-2013, 11:08 AM
RE: Carriage Stop - by EdK - 12-15-2013, 12:42 PM
RE: Carriage Stop - by awemawson - 12-15-2013, 01:53 PM
RE: Carriage Stop - by TomG - 12-15-2013, 02:23 PM
RE: Carriage Stop - by Hawkeye - 12-16-2013, 01:04 AM
RE: Carriage Stop - by stevec - 12-16-2013, 06:59 AM
RE: Carriage Stop - by Hawkeye - 12-16-2013, 11:52 PM



Users browsing this thread: 1 Guest(s)