MetalworkingFun Forum › Machinery › Lathes v
Tangential Toolholder

Thread Modes
Tangential Toolholder
EdK Offline
Whipping Boy
*******
Posts: 8,744
Threads: 314
Joined: Feb 2012
Location: Arizona/Minnesota
#11
12-27-2013, 12:18 PM
(12-27-2013, 11:43 AM)Hawkeye Wrote: I suppose you could make it like a machinist's jack, with the underside of the bolt head trued up and a good jam nut to lock it. That would make the initial setup a bit easier.

Smiley-signs009 I've seen them made that way.

Ed
Reply
Thanks given by:


Messages In This Thread
Tangential Toolholder - by Hawkeye - 12-25-2013, 12:42 AM
RE: Tangential Toolholder - by Arbalest - 12-25-2013, 05:58 AM
RE: Tangential Toolholder - by TomG - 12-25-2013, 02:22 PM
RE: Tangential Toolholder - by Hawkeye - 12-25-2013, 11:53 PM
RE: Tangential Toolholder - by Arbalest - 12-26-2013, 02:28 AM
RE: Tangential Toolholder - by the artfull-codger - 12-26-2013, 05:28 PM
RE: Tangential Toolholder - by Arbalest - 12-27-2013, 04:45 AM
RE: Tangential Toolholder - by the artfull-codger - 12-27-2013, 06:15 AM
RE: Tangential Toolholder - by Arbalest - 12-27-2013, 06:37 AM
RE: Tangential Toolholder - by the artfull-codger - 12-27-2013, 01:22 PM
RE: Tangential Toolholder - by Hawkeye - 12-27-2013, 11:43 AM
RE: Tangential Toolholder - by EdK - 12-27-2013, 12:18 PM
RE: Tangential Toolholder - by aRM - 05-09-2015, 11:40 PM
RE: Tangential Toolholder - by Arbalest - 12-27-2013, 03:57 PM
RE: Tangential Toolholder - by how'sitwork? - 05-06-2015, 04:57 PM
RE: Tangential Toolholder - by Arbalest - 05-10-2015, 04:28 AM



Users browsing this thread: 1 Guest(s)