Whitworth Thread on a M24/47
#2
I have threaded quite a few Mausers/GEW's in the lathe and have only used a 55 degree ground tool bit. I have never used a 60 degree but i have seen and read about people who do. Myself i would rather do it right and make them match...Bob
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Reply
Thanks given by:


Messages In This Thread
RE: Whitworth Thread on a M24/47 - by aametalmaster - 12-27-2013, 04:18 AM
RE: Whitworth Thread on a M24/47 - by awemawson - 12-27-2013, 05:04 AM
RE: Whitworth Thread on a M24/47 - by stevec - 12-27-2013, 07:22 AM
RE: Whitworth Thread on a M24/47 - by Highpower - 12-29-2013, 09:16 AM
RE: Whitworth Thread on a M24/47 - by unioncreek - 01-09-2014, 03:52 PM
RE: Whitworth Thread on a M24/47 - by unioncreek - 01-09-2014, 03:54 PM



Users browsing this thread: 1 Guest(s)