Quick Change Toolpost for Storebro
#32
(01-20-2014, 12:04 AM)Hawkeye Wrote: To my way of thinking, getting rid of the need for shims on the four-way or tweaking the rocker on the original toolpost makes almost anything else quick.

So true. I spent 6 years early in my career running a Polish-made lathe with a 27-1/2" (700mm) 4-jaw chuck and one of those 4-way indexing posts. I still have a pile of various shims in my toolbox. Getting tools raised to center height was always a chore, though nothing like trying to lower one!
Reply
Thanks given by:


Messages In This Thread
Quick Change Toolpost for Storebro - by Hawkeye - 12-31-2013, 12:46 AM
RE: Quick Change Toolpost for Storebro - by TomG - 01-07-2014, 12:12 PM
RE: Quick Change Toolpost for Storebro - by Shawn - 01-01-2014, 05:42 AM
RE: Quick Change Toolpost for Storebro - by EdK - 01-03-2014, 12:33 PM
RE: Quick Change Toolpost for Storebro - by Shawn - 01-19-2014, 03:23 AM
RE: Quick Change Toolpost for Storebro - by PixMan - 01-20-2014, 07:09 AM



Users browsing this thread: 1 Guest(s)