Centre round bar in a 4 jaw chuck
#7
Quite apart from the measuring needed to centre the 4-jaw, a good time-saving tip is to use two chuck keys in opposing jaws. It's quite amazing how much faster it is - so much so that if you don't have a second key it's actually worth while making one.
lemelman, proud to be a member of MetalworkingFun since Jul 2012.
Reply
Thanks given by:


Messages In This Thread
Centre round bar in a 4 jaw chuck - by DaveH - 03-28-2012, 04:35 PM
RE: Centre round bar in a 4 jaw chuck - by DaveH - 03-29-2012, 08:52 AM
RE: Centre round bar in a 4 jaw chuck - by lemelman - 07-16-2012, 06:13 AM
RE: Centre round bar in a 4 jaw chuck - by DaveH - 07-16-2012, 06:29 AM
RE: Centre round bar in a 4 jaw chuck - by DaveH - 07-16-2012, 09:00 AM
RE: Centre round bar in a 4 jaw chuck - by EdK - 11-11-2012, 11:02 AM



Users browsing this thread: 1 Guest(s)