Milling keyways in a long shaft?

Hello There, Guest! Register

Thread Modes

Milling keyways in a long shaft?

Sunset Machine Offline

Offline

Junior

Posts: 716
Threads: 32
Joined: Apr 2012
Location: Washington, USA

#10

01-18-2014, 09:35 AM

I've used just a plain u-bolt muffler clamp to index from.

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Milling keyways in a long shaft? - by cwoll - 01-17-2014, 01:18 AM

RE: Milling keyways in a long shaft? - by Gunney - 01-17-2014, 02:11 AM

RE: Milling keyways in a long shaft? - by cwoll - 01-17-2014, 10:32 AM

RE: Milling keyways in a long shaft? - by Gunney - 01-17-2014, 02:13 AM

RE: Milling keyways in a long shaft? - by big job - 01-17-2014, 08:58 AM

RE: Milling keyways in a long shaft? - by PixMan - 01-17-2014, 01:19 PM

RE: Milling keyways in a long shaft? - by wrustle - 01-17-2014, 05:43 PM

RE: Milling keyways in a long shaft? - by cwoll - 01-17-2014, 06:10 PM

RE: Milling keyways in a long shaft? - by TomG - 01-17-2014, 07:14 PM

RE: Milling keyways in a long shaft? - by Sunset Machine - 01-18-2014, 09:35 AM

Users browsing this thread: 1 Guest(s)