01-18-2014, 06:52 PM
There was a question on another forum about how to accurately measure a chamfer and since I've been meaning to add something similar to the my website, I decided that now was as good a time as any to crank one out.
The following chart can be used to accurately calculate the size and location of an angled surface, using a pin and a bit of trig. It will work for a dovetail, a chamfer, or any angled surface. I'll likely be shooting a video on how to use it tomorrow.
Tom
![[Image: Chamfer%20Calculations_2.JPG]](http://photos.imageevent.com/tomgriffin/generalstuff/large/Chamfer%20Calculations_2.JPG)
The following chart can be used to accurately calculate the size and location of an angled surface, using a pin and a bit of trig. It will work for a dovetail, a chamfer, or any angled surface. I'll likely be shooting a video on how to use it tomorrow.
Tom
![[Image: TomsTechLogo-Profile.png]](http://tomstechniques.com/wp-content/uploads/2013/11/TomsTechLogo-Profile.png)