MetalworkingFun Forum › Machining › General Metalworking Discussion v
1-2-3 blocks

Thread Modes
1-2-3 blocks
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,795
Threads: 183
Joined: Jun 2012
Location: Farmington Hills, Michigan
#18
02-02-2014, 10:52 AM
(02-02-2014, 10:16 AM)aametalmaster Wrote: When i was in HS Vocational Machine Trades in the '70s we made hundreds of them as a class project. But it taught layout, drilling tapping, case hardening and then the final grinding. Good beginners job making them even if not hard...Bob

Most everyone made them back then because they were a project that taught a lot of techniques. I have no idea what happened to mine, they must have been left behind on some job. 17428

Maybe I should get a grinder so I can make another set.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:


Messages In This Thread
1-2-3 blocks - by hswaters - 01-31-2014, 05:45 PM
RE: 1-2-3 blocks - by aametalmaster - 01-31-2014, 05:53 PM
RE: 1-2-3 blocks - by TomG - 01-31-2014, 07:10 PM
RE: 1-2-3 blocks - by krv3000 - 01-31-2014, 08:08 PM
RE: 1-2-3 blocks - by hswaters - 01-31-2014, 08:18 PM
RE: 1-2-3 blocks - by arvidj - 01-31-2014, 10:09 PM
RE: 1-2-3 blocks - by hswaters - 01-31-2014, 10:28 PM
RE: 1-2-3 blocks - by stevec - 02-01-2014, 07:40 AM
RE: 1-2-3 blocks - by Arbalest - 02-01-2014, 08:14 AM
RE: 1-2-3 blocks - by chucketn - 02-01-2014, 08:19 AM
RE: 1-2-3 blocks - by EdK - 02-01-2014, 07:01 PM
RE: 1-2-3 blocks - by PixMan - 02-01-2014, 07:30 PM
RE: 1-2-3 blocks - by EdK - 02-01-2014, 07:37 PM
RE: 1-2-3 blocks - by arvidj - 02-02-2014, 09:11 AM
RE: 1-2-3 blocks - by Mayhem - 02-01-2014, 11:38 PM
RE: 1-2-3 blocks - by arvidj - 02-02-2014, 09:22 AM
RE: 1-2-3 blocks - by aametalmaster - 02-02-2014, 10:16 AM
RE: 1-2-3 blocks - by TomG - 02-02-2014, 10:52 AM



Users browsing this thread: 1 Guest(s)