Cast And Plate
#18
380 @ 25 yards Rotfl They would hit the ground before they got to the target. But I do find a lot of 380 brass on the rang at the 25 yard line I wouldn't waste my time trying that. The little guns are good for concealment but that all there good for.

I carry a 45 APC in a shoulder holster I"ve taken it into most of the stores in town and know one is the wiser.

What I was shooting was my 38 large frame its a good shooter but I do prefer my 45.

Here in Alabama a concealed permit is $100.00 for 5 year $100.00 and if you have one you don't have to do a back ground test to buy and gun.

Paul
Old Iron`, proud to be a member of MetalworkingFun Forum since Feb 2014.
Reply
Thanks given by:


Messages In This Thread
Cast And Plate - by Old Iron - 02-18-2014, 10:55 PM
RE: Cast And Plate - by Highpower - 02-19-2014, 07:29 AM
RE: Cast And Plate - by aametalmaster - 02-19-2014, 08:47 PM
RE: Cast And Plate - by Mayhem - 02-20-2014, 08:21 AM
RE: Cast And Plate - by Welrod - 02-20-2014, 09:18 AM
RE: Cast And Plate - by Old Iron - 03-02-2014, 08:59 AM
RE: Cast And Plate - by Highpower - 03-02-2014, 04:25 PM
RE: Cast And Plate - by Welrod - 03-02-2014, 12:16 PM
RE: Cast And Plate - by Old Iron - 03-03-2014, 07:22 AM
RE: Cast And Plate - by Old Iron - 03-03-2014, 08:44 PM
RE: Cast And Plate - by Highpower - 03-03-2014, 10:24 PM
RE: Cast And Plate - by Old Iron - 03-04-2014, 06:01 AM
RE: Cast And Plate - by Mayhem - 03-04-2014, 07:24 AM
RE: Cast And Plate - by Highpower - 03-04-2014, 02:16 PM
RE: Cast And Plate - by Welrod - 03-04-2014, 02:09 PM
RE: Cast And Plate - by Old Iron - 03-05-2014, 07:35 AM
RE: Cast And Plate - by Highpower - 03-05-2014, 12:22 PM
RE: Cast And Plate - by Old Iron - 03-05-2014, 11:44 PM
RE: Cast And Plate - by Highpower - 03-06-2014, 11:19 AM
RE: Cast And Plate - by Old Iron - 03-06-2014, 10:48 PM
RE: Cast And Plate - by Highpower - 03-06-2014, 11:32 PM
RE: Cast And Plate - by Old Iron - 03-07-2014, 01:12 PM
RE: Cast And Plate - by Highpower - 03-07-2014, 02:36 PM



Users browsing this thread: 1 Guest(s)