air engine
#11
hi I sed I had bin hard at it did sum more to the air engine made up the connector from the crank to the piston then made the valve and valve  nut  to all that have joined the forum may not no that I don't have a mill so a lot of the work is dun by hand  right pics


Attached Files Thumbnail(s)
                           
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:


Messages In This Thread
air engine - by krv3000 - 02-22-2014, 03:42 PM
RE: air engine - by doubleboost - 02-22-2014, 03:54 PM
RE: air engine - by krv3000 - 02-22-2014, 04:24 PM
RE: air engine - by Micktoon - 02-22-2014, 06:16 PM
RE: air engine - by Mayhem - 02-22-2014, 08:21 PM
RE: air engine - by krv3000 - 03-02-2014, 05:37 PM
RE: air engine - by Micktoon - 03-03-2014, 05:33 PM
RE: air engine - by DaveH - 03-05-2014, 11:20 AM
RE: air engine - by krv3000 - 05-03-2015, 11:53 AM
RE: air engine - by krv3000 - 05-03-2015, 12:05 PM
RE: air engine - by krv3000 - 06-27-2015, 04:51 PM
RE: air engine - by Mayhem - 06-27-2015, 08:31 PM
RE: air engine - by krv3000 - 07-12-2015, 05:22 PM
RE: air engine - by Mayhem - 07-12-2015, 05:47 PM
RE: air engine - by Micktoon - 07-12-2015, 06:03 PM
RE: air engine - by EdK - 07-12-2015, 06:11 PM
RE: air engine - by krv3000 - 08-07-2015, 04:46 PM



Users browsing this thread: 1 Guest(s)