MetalworkingFun Forum › Machining › General Metalworking Discussion v
Measure twice, cut once.... what the heck?

Thread Modes
Measure twice, cut once.... what the heck?
PixMan Offline
Resident Pariah
******
Posts: 2,344
Threads: 53
Joined: Feb 2012
Location: Spencer MA USA
The following 3 users Like PixMan's post:
stevec (04-04-2014), Mayhem (04-04-2014), wrustle (04-09-2014)
#2
04-04-2014, 07:16 AM
I want to see the video of the repair on the faulty ones! I recall seeing a video showing recalibration of some cheap digital calipers....using a 2lb dead blow hammer.
Reply
Thanks given by:


Messages In This Thread
RE: Measure twice, cut once.... what the heck? - by PixMan - 04-04-2014, 07:16 AM



Users browsing this thread: 1 Guest(s)