| The following warnings occurred: | ||||||
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
|
|
Recommendation for mill?
|
04-03-2014, 07:17 PM
I'm looking to buy a mini mill this year. But, since I've never done any work with one I'm having trouble finding one. I'm looking at spending around $1500. I've looked at Grizzly and Enco, but can't decide on one. I've heard about problems with round column mills, but should I write them off? I'm not ruling out buying a used mill either if I know what to look for.
Bob |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Recommendation for mill? - by unioncreek - 04-03-2014, 07:17 PM
RE: Recommendation for mill? - by Hawkeye - 04-03-2014, 07:49 PM
RE: Recommendation for mill? - by EdK - 04-03-2014, 08:24 PM
RE: Recommendation for mill? - by Shawn - 04-04-2014, 01:14 AM
RE: Recommendation for mill? - by Mayhem - 04-05-2014, 11:38 PM
RE: Recommendation for mill? - by ScrapMetal - 04-06-2014, 01:39 AM
RE: Recommendation for mill? - by Shawn - 04-06-2014, 10:44 AM
RE: Recommendation for mill? - by roundrocktom - 04-06-2014, 12:33 PM
RE: Recommendation for mill? - by ScrapMetal - 04-06-2014, 07:59 PM
RE: Recommendation for mill? - by roundrocktom - 05-08-2014, 06:52 PM
RE: Recommendation for mill? - by Sunset Machine - 05-09-2014, 11:22 AM
RE: Recommendation for mill? - by Dr Stan - 07-08-2014, 08:56 PM
RE: Recommendation for mill? - by PixMan - 07-08-2014, 11:37 PM
|
