04-16-2014, 10:12 PM
Ed,
I would face the stock to length and drill and ream the 17mm hole. Then I would chuck a piece of stock and turn a stub arbor with a shoulder with a snug fit in the the reamed hole. Then you can slip the part on the stub arbor, center drill the opposite end and support it with a center to finish the O.D. This way there is no indicating to be done and the I.D. and O.D. will be perfectly concentric.
Tom
I would face the stock to length and drill and ream the 17mm hole. Then I would chuck a piece of stock and turn a stub arbor with a shoulder with a snug fit in the the reamed hole. Then you can slip the part on the stub arbor, center drill the opposite end and support it with a center to finish the O.D. This way there is no indicating to be done and the I.D. and O.D. will be perfectly concentric.
Tom
![[Image: TomsTechLogo-Profile.png]](http://tomstechniques.com/wp-content/uploads/2013/11/TomsTechLogo-Profile.png)