MetalworkingFun Forum › Machining › Projects v
Drip Oilers

Thread Modes
Drip Oilers
kenne Offline
Sophmore
***
Posts: 97
Threads: 5
Joined: Jun 2014
Location: las vegas burbs
The following 1 user Likes kenne's post:
DaveH (06-15-2014)
#8
06-15-2014, 03:34 PM
        [img]http://[/img]Sorry , I messed up the photo's ,trying to fix them , so I will try again .
the point was they are easy to make and cheaper than the high priced spread . I think the new photo's will show what I mean better than the old ones did . Here Goes ...
.
.
.
.
.
.
.
kenne, proud to be a member of MetalworkingFun Forum since Jun 2014.
Reply
Thanks given by:


Messages In This Thread
Drip Oilers - by kenne - 06-13-2014, 11:00 PM
RE: Drip Oilers - by stevec - 06-14-2014, 06:58 AM
RE: Drip Oilers - by kenne - 06-14-2014, 10:21 AM
RE: Drip Oilers - by stevec - 06-15-2014, 06:04 AM
RE: Drip Oilers - by Highpower - 06-15-2014, 06:46 AM
RE: Drip Oilers - by kenne - 06-15-2014, 03:57 PM
RE: Drip Oilers - by EdK - 06-15-2014, 04:09 PM
RE: Drip Oilers - by Hawkeye - 06-15-2014, 11:08 AM
RE: Drip Oilers - by EdK - 06-15-2014, 12:04 PM
RE: Drip Oilers - by kenne - 06-15-2014, 03:34 PM
RE: Drip Oilers - by kenne - 06-15-2014, 03:40 PM
RE: Drip Oilers - by Highpower - 06-16-2014, 08:15 AM
RE: Drip Oilers - by EdK - 06-16-2014, 11:59 AM
RE: Drip Oilers - by PixMan - 06-16-2014, 09:26 AM
RE: Drip Oilers - by kenne - 06-16-2014, 02:50 PM



Users browsing this thread: 1 Guest(s)