06-22-2014, 10:56 PM
(06-22-2014, 02:01 PM)Highpower Wrote: I've tried it in the past Jerry and never had any luck getting them to seal 100% afterwards. If I'm just doing a quick fix, I seal them up with an automotive FIPG (form in place gasket) compound that is used for sealing oil pans these days. Otherwise replacement tanks aren't too awfully expensive. It hurts less than the headache I got from trying to weld them.
YMMV.
Hi Willie,
Yes I've considered the easy way out but thought if i could get some coaching from some one that's been there done that I just might learn something new, trying as it may be!
Jerry
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.