Let's See Your Shop

[TOM REED]

(02-19-2012, 10:49 AM)DaveH Wrote: Tom,

I think your photo's came out very well, easy to look at.
:)
DaveH

PHOTOS LOOK GOOD no problem seeing them that is a 200 amp tig + stick welder combo on top of a 60 amp plasma cutter. both imported from CHINA from riverweld.com basically my first imports, the bothy work excellently and I sold my large Miller mig and 250 amp stick welder bought both of these plus lots of consumables and had about $500.00 left over. Stand is my make the commercially available ones were not large enough to accommodate the 60 amp plasma underneath. The large piece on the metal counter is the taper that came with my Logan, I would like too figure out who the maker is as I could prob get more seperate than along with the lathe. It bolts to the bottom and could prob fit an 18 to 20 inch swing lathe. Both of my boxes plus most of the cabinets are filled with tools etc some 40 yrs worth of collecting. tom