Ok here is my dilemma, I would like to replace my SB9b lathe and buy a slightly larger lathe with a QCGB. I have found a lathe and the owner is willing to either hold it for me or even deliver it for the cost of fuel. Problem is with work I am unable to drive the three hours to see the lathe in person. From the photos it would appear to be in good condition albeit a bit dirty (it has sat unused for 7 years) the bed ways are flame hardened and I doubt they will be in much worse shape that my 1950 vintage SB. I should be able to sell the SB for close to what the seller is asking for the Standard Modern so money isn't an issue. The Standard Modern has a 3 phase 240v motor so its a perfect candidate for a VFD as well. Someone tell me I'm crazy for considering this. 
![[Image: image.jpg]](http://s14.postimg.org/pa12w0ng1/image.jpg)
I will be the first to admit this is just metal illness causing me to consider the swap, here is what I will be replacing.
![[Image: image.jpg]](http://s30.postimg.org/e4nhomaht/image.jpg)
Cheers
Shawn
I will be the first to admit this is just metal illness causing me to consider the swap, here is what I will be replacing.
Cheers
Shawn
Shawn, proud to be a member of MetalworkingFun Forum since Nov 2013.