MetalworkingFun Forum › Machining › Metrology v
yet a gane a nuther d.t.i refit

Thread Modes
yet a gane a nuther d.t.i refit
doubleboost Offline
Super Moderator
******
Posts: 1,459
Threads: 159
Joined: Feb 2012
Location: Northern England
#5
08-25-2014, 03:22 PM
very skilfully done mate DroolDroolDrool
I have some watchmakers reamers
you will make better use of them than me
I try not to go below 4 mill YikesYikes
John
http://www.youtube.com/user/doubleboost
Reply
Thanks given by:


Messages In This Thread
yet a gane a nuther d.t.i refit - by krv3000 - 08-24-2014, 03:00 PM
RE: yet a gane a nuther d.t.i refit - by PixMan - 08-24-2014, 07:43 PM
RE: yet a gane a nuther d.t.i refit - by Mayhem - 08-25-2014, 05:24 AM
RE: yet a gane a nuther d.t.i refit - by krv3000 - 08-25-2014, 01:16 PM
RE: yet a gane a nuther d.t.i refit - by doubleboost - 08-25-2014, 03:22 PM
RE: yet a gane a nuther d.t.i refit - by krv3000 - 08-25-2014, 03:31 PM
RE: yet a gane a nuther d.t.i refit - by Micktoon - 08-25-2014, 05:48 PM
RE: yet a gane a nuther d.t.i refit - by vtsteam - 08-25-2014, 07:11 PM
RE: yet a gane a nuther d.t.i refit - by dallen - 08-25-2014, 08:16 PM
RE: yet a gane a nuther d.t.i refit - by krv3000 - 08-27-2014, 03:32 PM
RE: yet a gane a nuther d.t.i refit - by dallen - 08-27-2014, 05:25 PM
RE: yet a gane a nuther d.t.i refit - by krv3000 - 08-29-2014, 08:47 AM
RE: yet a gane a nuther d.t.i refit - by krv3000 - 08-30-2014, 03:21 PM
RE: yet a gane a nuther d.t.i refit - by RobWilson - 08-30-2014, 03:36 PM



Users browsing this thread: 1 Guest(s)