The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error




DRO Installation - Storebro Lathe
#1
It looks like we haven't had a DRO post since http://www.metalworkingfun.com/showthrea...al+Readout back in 2012, so I'll throw this one in.

I had installed iGaging DROs on the carriage, crossfeed and tailstock on the Storebro lathe since the dials on the lathe were metric (3 mm per turn). They were a great help, but the longitudinal DRO started acting up. It would run away, counting up a hundred or so inches when nothing was moving. I finally ordered a two-axis set from Singapore - looks like the same ones featured in the above link.

I did the crossfeed scale first. It's a fair bit bulkier than the iGaging one, but I did order the 'slim' one for that location. I lose about 1/2" of over-the-carriage radius with it. I can always remove it if I ever have to turn an 11 1/2" cylinder. Yikes
   
   

I got the longest scale they carry in the 'standard' size - 920 mm travel. One of the nice things about the Storebro is the squared off arms on the carriage. Makes it easy to attach things. I re-used the holes that the old reader was fastened to. The kit comes with some very solid aluminum brackets.
   

At the headstock end, I used an extended bracket to place the mounting point past the removable section of the bed. I can't see ever opening the gap, but I didn't want to attach anything to it.
   

The tailstock end was shimmed out and bolted directly to the frame.
   

The long scale was finished off with the supplied shield.
   

I have a shelf unit set up as a backboard behind the lathe. It made a good place to mount the display.
   

There are a few features in this system that I'm going to like. There is an error compensation facility to improve accuracy, and a system for measuring angles. You can also select between display in radius or diameter for the crossfeed.
Mike

If you can't get one, make one.

Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by:


Messages In This Thread
DRO Installation - Storebro Lathe - by Hawkeye - 08-24-2014, 09:34 PM
RE: DRO Installation - Storebro Lathe - by Mayhem - 08-25-2014, 05:19 AM
RE: DRO Installation - Storebro Lathe - by tackit - 08-25-2014, 07:52 PM



Users browsing this thread: 1 Guest(s)