MetalworkingFun Forum › Machining › General Metalworking Discussion v
Douglas shaper in slow motion

Thread Modes
Douglas shaper in slow motion
stevec Offline
69 yr. old senior
*****
Posts: 2,685
Threads: 29
Joined: Feb 2012
Location: Nova Scotia, Canada
#14
10-01-2014, 07:44 AM
I still have the Havir shaper I broke during my move here in '09. I plan to repair it someday but it is probably the lowest on the loooong list of priorities. Blush
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:


Messages In This Thread
Douglas shaper in slow motion - by Shawn - 09-30-2014, 03:02 PM
RE: Douglas shaper in slow motion - by TomG - 09-30-2014, 03:13 PM
RE: Douglas shaper in slow motion - by EdK - 09-30-2014, 03:25 PM
RE: Douglas shaper in slow motion - by Shawn - 09-30-2014, 03:42 PM
RE: Douglas shaper in slow motion - by Shawn - 09-30-2014, 03:47 PM
RE: Douglas shaper in slow motion - by TomG - 09-30-2014, 05:45 PM
RE: Douglas shaper in slow motion - by stevec - 09-30-2014, 03:52 PM
RE: Douglas shaper in slow motion - by Shawn - 09-30-2014, 03:58 PM
RE: Douglas shaper in slow motion - by f350ca - 09-30-2014, 04:55 PM
RE: Douglas shaper in slow motion - by Artie - 09-30-2014, 10:14 PM
RE: Douglas shaper in slow motion - by PixMan - 09-30-2014, 10:54 PM
RE: Douglas shaper in slow motion - by Shawn - 10-01-2014, 12:59 AM
RE: Douglas shaper in slow motion - by stevec - 10-01-2014, 07:44 AM



Users browsing this thread: 1 Guest(s)