MetalworkingFun Forum › Machining › Projects v
Wood Lathe Exert

Thread Modes
Wood Lathe Exert
f350ca Offline
Senior
*****
Posts: 3,002
Threads: 51
Joined: Apr 2012
Location: Ontario
#3
10-09-2014, 06:21 PM (This post was last modified: 10-09-2014, 06:22 PM by f350ca.)
I agree with dallen's method, but you might need to make the outside threaded spindle first to check the internal threads on the adaptor, then put it in the 4 jaw and dial it in to finish the adaptor.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:


Messages In This Thread
Wood Lathe Exert - by solidedge - 10-09-2014, 03:24 AM
RE: Wood Lathe Exert - by dallen - 10-09-2014, 04:16 PM
RE: Wood Lathe Exert - by f350ca - 10-09-2014, 06:21 PM
RE: Wood Lathe Exert - by TomG - 10-09-2014, 06:39 PM
RE: Wood Lathe Exert - by solidedge - 10-10-2014, 01:52 AM
RE: Wood Lathe Exert - by EdK - 10-10-2014, 05:11 AM
RE: Wood Lathe Exert - by TomG - 10-10-2014, 07:24 AM
RE: Wood Lathe Exert - by solidedge - 10-13-2014, 09:51 AM
RE: Wood Lathe Exert - by solidedge - 10-13-2014, 09:55 AM
RE: Wood Lathe Exert - by solidedge - 10-14-2014, 03:03 PM



Users browsing this thread: 1 Guest(s)