The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error



MetalworkingFun Forum › Machining › General Metalworking Discussion v
Flywheel pattern making

Thread Modes
Flywheel pattern making
chucketn Offline
Junior
****
Posts: 375
Threads: 53
Joined: Jun 2013
Location: Jonesborough, TN
#1
10-25-2014, 11:47 AM
I am researching making patterns to cast al flywheels. I found a drawing from Elmer Verberg’s info at the Jon-Tom website. How do I machine the tapered spokes,  shown in the drawing below, on a rotary table? I can understand the setup for drilling the corner holes for the cutouts, but how do I offset  for the taper of the spokes?
Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
Reply
Thanks given by:


Messages In This Thread
Flywheel pattern making - by chucketn - 10-25-2014, 11:47 AM
RE: Flywheel pattern making - by dallen - 10-25-2014, 01:15 PM
RE: Flywheel pattern making - by f350ca - 10-25-2014, 01:23 PM
RE: Flywheel pattern making - by texx - 10-25-2014, 07:43 PM
RE: Flywheel pattern making - by chucketn - 10-26-2014, 06:33 AM
RE: Flywheel pattern making - by Dr Stan - 11-06-2014, 10:21 PM
RE: Flywheel pattern making - by chucketn - 11-07-2014, 06:46 AM
RE: Flywheel pattern making - by Dr Stan - 11-16-2014, 07:22 PM



Users browsing this thread: 1 Guest(s)