The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error




DRO On Lathe
#1
Anyone that has a DRO on your lathe can you tell me if you have this feature?

I've drilled a thru-hole in the piece and then bored it just enough to get a good finish. I've measured the hole with an inside micrometer and now I want to bore it to size. I can set the lathe axis to the starting diameter but when I go to bore it to size the display reads a smaller number as I increase the hole size. I could do the arithmetic but it seems like there should be a function in the DRO to do this. Maybe there is and I'm just not understanding the nomenclature in the manual. So does anyone know if their DRO can do what I'm trying to do, display the size of the bored hole properly as it's enlarged?

Ed
Reply
Thanks given by:


Messages In This Thread
DRO On Lathe - by EdK - 01-27-2015, 11:03 AM
RE: DRO On Lathe - by PixMan - 01-27-2015, 11:40 AM
RE: DRO On Lathe - by f350ca - 01-27-2015, 12:17 PM
RE: DRO On Lathe - by EdK - 01-27-2015, 12:26 PM
RE: DRO On Lathe - by PixMan - 01-27-2015, 12:40 PM
RE: DRO On Lathe - by EdK - 01-27-2015, 12:56 PM
RE: DRO On Lathe - by EdK - 01-27-2015, 12:49 PM
RE: DRO On Lathe - by f350ca - 01-27-2015, 02:20 PM
RE: DRO On Lathe - by EdK - 01-27-2015, 02:32 PM
RE: DRO On Lathe - by stevec - 01-27-2015, 02:42 PM
RE: DRO On Lathe - by EdK - 01-27-2015, 03:02 PM
RE: DRO On Lathe - by EdK - 01-27-2015, 04:31 PM
RE: DRO On Lathe - by PixMan - 01-27-2015, 05:02 PM
RE: DRO On Lathe - by DriftStar - 01-27-2015, 05:10 PM
RE: DRO On Lathe - by EdK - 01-27-2015, 06:00 PM
RE: DRO On Lathe - by f350ca - 01-27-2015, 06:09 PM
RE: DRO On Lathe - by EdK - 01-27-2015, 06:23 PM



Users browsing this thread: 2 Guest(s)