MetalworkingFun Forum › Machinery › Milling Machines v
[HELP] Centering on a rotary table

Thread Modes
Help Centering on a rotary table
Shawn Offline
Junior
****
Posts: 313
Threads: 34
Joined: Nov 2013
Location: Kamloops, BC, Canada
#8
01-30-2015, 05:13 AM
If you cut the disk on your lathe, use a centre drill to indicate the centre of the disk and then use a centre finder on your mill to indicate the part and the disk. 

[Image: 250.1240.jpg]
Shawn, proud to be a member of MetalworkingFun Forum since Nov 2013.
Reply
Thanks given by:


Messages In This Thread
Centering on a rotary table - by Dan Boy - 01-29-2015, 01:55 PM
RE: Centering on a rotary table - by DaveH - 01-29-2015, 01:59 PM
RE: Centering on a rotary table - by Highpower - 01-29-2015, 04:30 PM
RE: Centering on a rotary table - by f350ca - 01-29-2015, 06:10 PM
RE: Centering on a rotary table - by PixMan - 01-29-2015, 08:48 PM
RE: Centering on a rotary table - by Dan Boy - 01-30-2015, 01:53 AM
RE: Centering on a rotary table - by Dan Boy - 01-30-2015, 01:54 AM
RE: Centering on a rotary table - by Shawn - 01-30-2015, 05:13 AM
RE: Centering on a rotary table - by RobWilson - 01-30-2015, 01:48 PM
RE: Centering on a rotary table - by TomG - 01-30-2015, 06:09 PM
RE: Centering on a rotary table - by Shawn - 01-31-2015, 02:58 AM
RE: Centering on a rotary table - by Maxiice - 01-31-2015, 11:01 AM
RE: Centering on a rotary table - by ScrapMetal - 02-02-2015, 10:50 PM



Users browsing this thread: 1 Guest(s)