MetalworkingFun Forum › Machining › How-To's v
mill head to table align'

Thread Modes
mill head to table align'
dallen Offline
Senior
*****
Posts: 1,827
Threads: 51
Joined: Apr 2012
Location: Oklahoma
The following 1 user Likes dallen's post:
Mayhem (10-29-2015)
#12
10-29-2015, 11:59 AM
go to the parts store and get yourself a cheap brake rotor that is big enough to cover the table and use that to run the indicator on
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:


Messages In This Thread
mill head to table align' - by chanse - 02-08-2015, 09:02 PM
RE: mill head to table align' - by Highpower - 02-09-2015, 12:46 AM
RE: mill head to table align' - by fix - 02-09-2015, 11:13 AM
RE: mill head to table align' - by Vinny - 02-09-2015, 03:07 PM
RE: mill head to table align' - by Dr Stan - 02-09-2015, 11:21 PM
RE: mill head to table align' - by chanse - 02-11-2015, 08:55 PM
RE: mill head to table align' - by Shawn - 02-19-2015, 01:56 AM
RE: mill head to table align' - by Roadracer_Al - 02-19-2015, 02:08 AM
RE: mill head to table align' - by Shawn - 02-19-2015, 10:14 AM
RE: mill head to table align' - by Arbalest - 02-19-2015, 05:58 AM
RE: mill head to table align' - by CNCAZ - 10-29-2015, 09:47 AM
RE: mill head to table align' - by dallen - 10-29-2015, 11:59 AM



Users browsing this thread: 1 Guest(s)