02-14-2015, 03:27 PM
hi well one of the tool cumpanes seles a grinding fixture that you use on a surfice grinder to resharpen the bottoms of cuters
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
|
sharpening end mills by hand.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
sharpening end mills by hand. - by fix - 02-10-2015, 03:59 PM
RE: sharpening end mills by hand. - by Terry S - 02-10-2015, 07:10 PM
RE: sharpening end mills by hand. - by fix - 02-10-2015, 07:32 PM
RE: sharpening end mills by hand. - by f350ca - 02-10-2015, 08:17 PM
RE: sharpening end mills by hand. - by fix - 02-10-2015, 08:33 PM
RE: sharpening end mills by hand. - by Sunset Machine - 02-10-2015, 08:35 PM
RE: sharpening end mills by hand. - by fix - 02-10-2015, 08:52 PM
RE: sharpening end mills by hand. - by Dr Stan - 02-10-2015, 10:54 PM
RE: sharpening end mills by hand. - by how'sitwork? - 02-11-2015, 05:36 PM
RE: sharpening end mills by hand. - by PixMan - 02-11-2015, 11:38 PM
RE: sharpening end mills by hand. - by krv3000 - 02-14-2015, 03:27 PM
|
Users browsing this thread: 1 Guest(s)