02-11-2015, 08:44 PM
I hadn't thought about just milling it flat and adding a whole new lug. That might be the most graceful way to solve the problem.
I'll look, but I think the base is thick enough to add screws, and I need to narrow the whole thing by about 1/8 inch to clear my saddle arms anyway. I might be able to mount the thing upside down on my mill and do all the work with one setup.
I'll look, but I think the base is thick enough to add screws, and I need to narrow the whole thing by about 1/8 inch to clear my saddle arms anyway. I might be able to mount the thing upside down on my mill and do all the work with one setup.