|
How to adjust?
|
02-19-2015, 07:16 AM
(02-19-2015, 07:07 AM)jeephaydon Wrote: I'm not moving the whole carriage, just the smaller top slide, because the carrige wheel is so high geared. And no i don't back the tool out. The centre hight and everything is okay. Haydon, I would then guess that you have play in the cross slide and/or the compound slide. Have you tried adjusting the gibs? Steve 
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
How to adjust? - by jeephaydon - 02-18-2015, 07:11 PM
RE: How to adjust? - by stevec - 02-18-2015, 07:24 PM
RE: How to adjust? - by DaveH - 02-18-2015, 07:35 PM
RE: How to adjust? - by jeephaydon - 02-18-2015, 08:00 PM
RE: How to adjust? - by stevec - 02-18-2015, 08:53 PM
RE: How to adjust? - by jeephaydon - 02-19-2015, 07:07 AM
RE: How to adjust? - by stevec - 02-19-2015, 07:16 AM
RE: How to adjust? - by Sunset Machine - 02-19-2015, 08:20 AM
RE: How to adjust? - by DaveH - 02-19-2015, 09:54 AM
RE: How to adjust? - by EdK - 02-19-2015, 12:37 PM
RE: How to adjust? - by stevec - 02-20-2015, 07:39 AM
RE: How to adjust? - by Micktoon - 02-20-2015, 06:50 PM
RE: How to adjust? - by Dr Stan - 02-21-2015, 08:16 PM
RE: How to adjust? - by jeephaydon - 02-23-2015, 01:49 PM
|
