MetalworkingFun Forum › Machining › Projects v
Countershaft for horizontal mill

Thread Modes
Countershaft for horizontal mill
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
The following 3 users Like Mayhem's post:
PixMan (02-24-2015), Highpower (02-24-2015), arvidj (02-26-2015)
#2
02-24-2015, 05:43 AM
(02-24-2015, 03:11 AM)Shawn Wrote: ...I am even going to paint the countershaft boring old grey to match the mill, even though I got a few cans of Chevy orange left  Cool ...

Smart decision. Use the Chevy orange when you wish to speed things up. Grey or (even better) Ford blue is an appropriate choice when slowing things down Big Grin

Nice job thus far.
Hunting American dentists since 2015.
Reply
Thanks given by: Shawn


Messages In This Thread
Countershaft for horizontal mill - by Shawn - 02-24-2015, 03:11 AM
RE: Countershaft for horizontal mill - by Mayhem - 02-24-2015, 05:43 AM
RE: Countershaft for horizontal mill - by Shawn - 02-26-2015, 01:48 AM
RE: Countershaft for horizontal mill - by Shawn - 02-26-2015, 11:39 AM
RE: Countershaft for horizontal mill - by Shawn - 02-26-2015, 02:24 PM
RE: Countershaft for horizontal mill - by Shawn - 02-26-2015, 05:15 PM
RE: Countershaft for horizontal mill - by f350ca - 02-26-2015, 05:26 PM
RE: Countershaft for horizontal mill - by Shawn - 02-26-2015, 10:30 PM
RE: Countershaft for horizontal mill - by Shawn - 03-01-2015, 06:01 AM
RE: Countershaft for horizontal mill - by DaveH - 03-01-2015, 09:27 AM
RE: Countershaft for horizontal mill - by Shawn - 03-01-2015, 04:46 PM
RE: Countershaft for horizontal mill - by stevec - 03-01-2015, 08:41 PM
RE: Countershaft for horizontal mill - by f350ca - 03-01-2015, 08:59 PM



Users browsing this thread: 1 Guest(s)