Countershaft for horizontal mill
#8
I couldn't think of any good reason not to use an idler either. I'm going to use a weighted idler pulley then that can be easily adjusted to follow the 5 speed changes.

Cheers
Shawn
Shawn, proud to be a member of MetalworkingFun Forum since Nov 2013.
Reply
Thanks given by:


Messages In This Thread
Countershaft for horizontal mill - by Shawn - 02-24-2015, 03:11 AM
RE: Countershaft for horizontal mill - by Mayhem - 02-24-2015, 05:43 AM
RE: Countershaft for horizontal mill - by Shawn - 02-26-2015, 01:48 AM
RE: Countershaft for horizontal mill - by Shawn - 02-26-2015, 11:39 AM
RE: Countershaft for horizontal mill - by Shawn - 02-26-2015, 02:24 PM
RE: Countershaft for horizontal mill - by Shawn - 02-26-2015, 05:15 PM
RE: Countershaft for horizontal mill - by f350ca - 02-26-2015, 05:26 PM
RE: Countershaft for horizontal mill - by Shawn - 02-26-2015, 10:30 PM
RE: Countershaft for horizontal mill - by Shawn - 03-01-2015, 06:01 AM
RE: Countershaft for horizontal mill - by DaveH - 03-01-2015, 09:27 AM
RE: Countershaft for horizontal mill - by Shawn - 03-01-2015, 04:46 PM
RE: Countershaft for horizontal mill - by stevec - 03-01-2015, 08:41 PM
RE: Countershaft for horizontal mill - by f350ca - 03-01-2015, 08:59 PM



Users browsing this thread: 1 Guest(s)