Countershaft for horizontal mill
#17
I found about 12 feet of it at the local shopping centre (dump) The stuff I found is a little heavier and assembles with rivets. When the belts on my table saw failed (prematurely, they only lasted about 30 years) I tired the link belt. Maybe not a fair test, they run as a matched pair and are really short, but I could not get them to stop slipping under heavy load.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:


Messages In This Thread
Countershaft for horizontal mill - by Shawn - 02-24-2015, 03:11 AM
RE: Countershaft for horizontal mill - by Mayhem - 02-24-2015, 05:43 AM
RE: Countershaft for horizontal mill - by Shawn - 02-26-2015, 01:48 AM
RE: Countershaft for horizontal mill - by Shawn - 02-26-2015, 11:39 AM
RE: Countershaft for horizontal mill - by Shawn - 02-26-2015, 02:24 PM
RE: Countershaft for horizontal mill - by Shawn - 02-26-2015, 05:15 PM
RE: Countershaft for horizontal mill - by f350ca - 02-26-2015, 05:26 PM
RE: Countershaft for horizontal mill - by Shawn - 02-26-2015, 10:30 PM
RE: Countershaft for horizontal mill - by Shawn - 03-01-2015, 06:01 AM
RE: Countershaft for horizontal mill - by DaveH - 03-01-2015, 09:27 AM
RE: Countershaft for horizontal mill - by Shawn - 03-01-2015, 04:46 PM
RE: Countershaft for horizontal mill - by stevec - 03-01-2015, 08:41 PM
RE: Countershaft for horizontal mill - by f350ca - 03-01-2015, 08:59 PM



Users browsing this thread: 1 Guest(s)