work holding device
#9
Grabbed 20 minutes in the shop tonight Big Grin
[Image: normal_P1040795.jpg]
I used a bit 1' 1/4" SS hex for the handle ,, using steel for the handle means i can mount it in the bench vice if needs be ,,,,,,,,,,, may make one for the 3/8 chuck tomorrow Popcorn

Cheers for sharing your idea Bob Smiley-signs107

Rob
Reply
Thanks given by:


Messages In This Thread
work holding device - by krv3000 - 04-09-2012, 03:59 PM
RE: work holding device - by ETC57 - 04-09-2012, 05:40 PM
RE: work holding device - by DaveH - 04-09-2012, 06:17 PM
RE: work holding device - by EdK - 04-09-2012, 06:32 PM
RE: work holding device - by Highpower - 04-09-2012, 08:00 PM
RE: work holding device - by RobWilson - 04-10-2012, 11:12 AM
RE: work holding device - by aametalmaster - 04-10-2012, 05:26 PM
RE: work holding device - by krv3000 - 04-10-2012, 06:25 PM
RE: work holding device - by RobWilson - 04-11-2012, 03:10 PM
RE: work holding device - by krv3000 - 04-11-2012, 05:34 PM



Users browsing this thread: 1 Guest(s)