|
My DRO install
|
|
03-22-2015, 01:56 AM
On Z, up towards the spindle is minus, dropping away is plus. On X, moving the table left (spindle to the right) is plus. On Y moving the saddle toward you (spindle toward the solid jaw of the vise) is plus.
At least that's the way it is on my Prototrak and all CNC vertcal machining centers i've ever programmed. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
My DRO install - by mike-sid - 03-07-2015, 09:06 PM
RE: My DRO install - by EdK - 03-07-2015, 09:08 PM
RE: My DRO install - by Mayhem - 03-07-2015, 09:51 PM
RE: My DRO install - by mike-sid - 03-09-2015, 09:47 PM
RE: My DRO install - by Mayhem - 03-10-2015, 06:08 AM
RE: My DRO install - by mike-sid - 03-11-2015, 10:44 AM
RE: My DRO install - by mike-sid - 03-11-2015, 10:58 AM
RE: My DRO install - by mike-sid - 03-11-2015, 01:50 PM
RE: My DRO install - by EdK - 03-11-2015, 04:33 PM
RE: My DRO install - by PixMan - 03-11-2015, 09:31 PM
RE: My DRO install - by mike-sid - 03-11-2015, 10:02 PM
RE: My DRO install - by Mayhem - 03-11-2015, 10:23 PM
RE: My DRO install - by PixMan - 03-11-2015, 11:05 PM
RE: My DRO install - by mike-sid - 03-12-2015, 05:25 AM
RE: My DRO install - by mike-sid - 03-14-2015, 03:07 PM
RE: My DRO install - by mike-sid - 03-14-2015, 03:15 PM
RE: My DRO install - by EdK - 03-14-2015, 04:47 PM
RE: My DRO install - by DaveH - 03-14-2015, 05:04 PM
RE: My DRO install - by mike-sid - 03-14-2015, 08:29 PM
RE: My DRO install - by Mayhem - 03-14-2015, 05:52 PM
RE: My DRO install - by mike-sid - 03-14-2015, 06:01 PM
RE: My DRO install - by Mayhem - 03-14-2015, 06:03 PM
RE: My DRO install - by mike-sid - 03-14-2015, 08:32 PM
RE: My DRO install - by Mayhem - 03-14-2015, 10:08 PM
RE: My DRO install - by mike-sid - 03-15-2015, 06:27 PM
RE: My DRO install - by mike-sid - 03-21-2015, 10:10 PM
RE: My DRO install - by PixMan - 03-22-2015, 01:56 AM
RE: My DRO install - by Mayhem - 03-22-2015, 03:04 AM
RE: My DRO install - by mike-sid - 03-22-2015, 05:47 AM
RE: My DRO install - by mike-sid - 03-23-2015, 09:55 PM
|
