|
Lathe spindle mounted boring head.
|
 (04-10-2012, 07:02 PM)aametalmaster Wrote: ... I have used it a few times but the most it gets used is when i cut the round bolt knob off of Remington 700 bolts to thread for a longer bolt knob. Bob, I would like to see that next time you get around to doing one, if you don't mind.  [Edit:] Oooops... I should have read further ahead in the threads. Thanks Bob! Make up a center to put in that boring head and pop it in the tail stock for doing quick tapers. 
Willie
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Lathe spindle mounted boring head. - by aametalmaster - 04-10-2012, 07:02 PM
RE: Lathe spindle mounted boring head. - by DaveH - 04-10-2012, 07:15 PM
RE: Lathe spindle mounted boring head. - by aametalmaster - 04-10-2012, 07:17 PM
RE: Lathe spindle mounted boring head. - by stevec - 04-10-2012, 07:19 PM
RE: Lathe spindle mounted boring head. - by Highpower - 04-10-2012, 08:39 PM
|
