04-11-2012, 03:43 AM
(04-10-2012, 09:46 PM)Highpower Wrote: Bob,
In the picture with the threading die....
Is that a drive socket to the left of the die? Do you "power" thread the bolt stem, or do it by hand?
The round bar has a small hole for the threads to go thru i just use it to line up the die and turn it with a wrench...Bob
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...