08-09-2015, 06:39 AM
Squaring up the rotary table on the mill. I noticed that at 0° the T slot opposite the zero was out of square by 2° 30'
I shifted the pointer to correct this, Prior to drilling the jig.
The jig was located on the spigot and drilled with 3 holes that fit the table and the nose of the lathe.
5 extra holes where added that will match the position of the accessory shafts in the case for fixings.
It all looks good to go, so the next job is the jig for the cylinders.
Brian
I shifted the pointer to correct this, Prior to drilling the jig.
The jig was located on the spigot and drilled with 3 holes that fit the table and the nose of the lathe.
5 extra holes where added that will match the position of the accessory shafts in the case for fixings.
It all looks good to go, so the next job is the jig for the cylinders.
Brian
