Transfer punches
#1
I make these from scrap and pass them out at work. We always need bigger transfer punches for plates with big holes to mark on blank plates to be drilled. Just use a smaller transfer punch in this bigger pointed bushing to mark the center hole. I have them to 2"...Bob


Attached Files Thumbnail(s)
       
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Reply
Thanks given by:


Messages In This Thread
Transfer punches - by aametalmaster - 04-10-2012, 08:04 PM
RE: Transfer punches - by mikecwik - 04-10-2012, 10:13 PM
RE: Transfer punches - by pjf134 - 04-10-2012, 10:18 PM
RE: Transfer punches - by aametalmaster - 04-11-2012, 03:45 AM
RE: Transfer punches - by f350ca - 04-10-2012, 11:13 PM
RE: Transfer punches - by krv3000 - 04-11-2012, 01:53 AM
RE: Transfer punches - by pjf134 - 04-11-2012, 09:27 AM
RE: Transfer punches - by aametalmaster - 04-11-2012, 04:36 PM
RE: Transfer punches - by EdK - 04-11-2012, 04:52 PM
RE: Transfer punches - by aametalmaster - 04-11-2012, 05:09 PM



Users browsing this thread: 1 Guest(s)