Transfer punches

Thread Modes

Transfer punches

aametalmaster Offline

MTLMSTR

Posts: 410
Threads: 77
Joined: Mar 2012
Location: Salem, Ohio

#10

04-11-2012, 05:09 PM

(04-11-2012, 04:52 PM)EdAK Wrote: [quote='aametalmaster' pid='2470' dateline='1334180169']
[quote='pjf134' pid='2449' dateline='1334154453']

How do you make sure you are holding the punch at an exact right angle to the work with the tapered nose? It seems like you could have it cocked slightly and your punch mark won't end up exactly where you want it.

Thanks,
Ed

I have a trained eye ;) But you are right...Bob

Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...

Like Post

« Next Oldest | Next Newest »

Messages In This Thread

Transfer punches - by aametalmaster - 04-10-2012, 08:04 PM

RE: Transfer punches - by mikecwik - 04-10-2012, 10:13 PM

RE: Transfer punches - by pjf134 - 04-10-2012, 10:18 PM

RE: Transfer punches - by aametalmaster - 04-11-2012, 03:45 AM

RE: Transfer punches - by f350ca - 04-10-2012, 11:13 PM

RE: Transfer punches - by krv3000 - 04-11-2012, 01:53 AM

RE: Transfer punches - by pjf134 - 04-11-2012, 09:27 AM