Induction Motors

Thread Modes

Induction Motors

starlight_tools Offline

Sophmore

Posts: 139
Threads: 14
Joined: Apr 2012
Location: Nelson, BC, Canada

#16

05-18-2015, 10:29 PM

Lookin' good so far.

If the current is within spec with the motor driving the fan, you should be fine.

Walter

starlight_tools, proud to be a member of Metalworking Forum since Apr 2012.

« Next Oldest | Next Newest »

Messages In This Thread

Induction Motors - by f350ca - 05-13-2015, 10:46 PM

RE: Induction Motors - by stevec - 05-14-2015, 06:04 AM

RE: Induction Motors - by Terry S - 05-14-2015, 07:57 AM

RE: Induction Motors - by f350ca - 05-14-2015, 08:28 AM

RE: Induction Motors - by stevec - 05-14-2015, 09:34 AM

RE: Induction Motors - by Terry S - 05-14-2015, 09:58 AM

RE: Induction Motors - by f350ca - 05-14-2015, 12:05 PM

RE: Induction Motors - by stevec - 05-14-2015, 05:54 PM

RE: Induction Motors - by Vinny - 05-14-2015, 06:04 PM

RE: Induction Motors - by f350ca - 05-14-2015, 06:57 PM

RE: Induction Motors - by f350ca - 05-16-2015, 04:35 PM

RE: Induction Motors - by f350ca - 05-18-2015, 06:32 PM

RE: Induction Motors - by starlight_tools - 05-18-2015, 10:29 PM

Users browsing this thread: 2 Guest(s)