|
Carbide tool grinders.
|
 (02-02-2013, 10:56 AM)stevec Wrote: ... but then, I am blessed with the Baldor version (Thanks again Claude). Steve,   Enco numbers Resin bonded: 317-1067 for the 1/2" wide face (220 grit) 317-1070 for the 3/4" wide face (220 grit) Electroplated: 391-5640 for the 3/4" wide face (220 grit) 307-3449 for the 1" wide face (220 grit)
Willie
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Carbide tool grinders. - by Highpower - 04-11-2012, 12:58 PM
RE: Carbide tool grinders. - by DaveH - 04-11-2012, 01:51 PM
RE: Carbide tool grinders. - by TOM REED - 04-11-2012, 02:47 PM
RE: Carbide tool grinders. - by Highpower - 04-11-2012, 04:15 PM
RE: Carbide tool grinders. - by EdK - 04-11-2012, 05:04 PM
RE: Carbide tool grinders. - by Highpower - 04-11-2012, 08:52 PM
RE: Carbide tool grinders. - by arvidj - 04-11-2012, 09:33 PM
RE: Carbide tool grinders. - by arvidj - 02-01-2013, 11:35 PM
RE: Carbide tool grinders. - by Highpower - 02-02-2013, 12:38 AM
RE: Carbide tool grinders. - by arvidj - 02-02-2013, 11:24 AM
RE: Carbide tool grinders. - by stevec - 02-02-2013, 10:56 AM
RE: Carbide tool grinders. - by Highpower - 02-02-2013, 11:06 AM
RE: Carbide tool grinders. - by Highpower - 02-02-2013, 11:44 AM
RE: Carbide tool grinders. - by arvidj - 02-02-2013, 01:01 PM
RE: Carbide tool grinders. - by Highpower - 02-04-2013, 12:26 PM
RE: Carbide tool grinders. - by stevec - 02-02-2013, 02:12 PM
RE: Carbide tool grinders. - by sasquatch - 02-02-2013, 04:29 PM
RE: Carbide tool grinders. - by EdK - 02-02-2013, 05:54 PM
RE: Carbide tool grinders. - by EdK - 02-04-2013, 12:30 PM
RE: Carbide tool grinders. - by Highpower - 02-04-2013, 01:29 PM
RE: Carbide tool grinders. - by EdK - 02-04-2013, 01:38 PM
RE: Carbide tool grinders. - by Highpower - 02-04-2013, 01:49 PM
RE: Carbide tool grinders. - by f350ca - 02-04-2013, 01:44 PM
RE: Carbide tool grinders. - by Highpower - 02-04-2013, 01:51 PM
|
